Section 7. Programming Log And Quick Reference
7-5
69# ___# Repeat Courtesy Tone
(0 = Disabled, 1 = Enabled)
0
70# ___# Set VOX Sample Rate (0.5 to 1.5 seconds, in
100 ms increments, entry range is 5 to 15)
10
73# ___# Set VOX Hold Time (0.5 to 1.5 seconds, in 100
ms increments, entry range is 5 to 15)
10
78# ___# Automatic Sample Window Setup (only from
radio)
79# ___# Increment Sample Window by 10 ms
80# ___# Decrement Sample Window by 10 ms
81# ___# Set COR Hold Time (0 to 500 ms, in 100 ms
increments)
0
85# ___# Set Busy Tone Detect Mode
0 = Busy Tone Detection Disabled
1 = Disconnect If Busy Detected in First 20
Seconds
2 = Disconnect If Busy Detected During Entire Call
1
87# ___# Use Auxiliary Output for PL Strip
(0 = Disabled, 1 = Enabled)
0
88# ___# Set Auxiliary Output ON Code (1 to 9 digits) 567
89# ___# Set Auxiliary Output OFF Code (1 to 9 digits) 890
90# ______# Set Program Access Code 12030
91# Reset All Memory to Factory Defaults
92# Transmit Level Test
93# Repeat Audio Test / Receive Level Adjustment
94# Enable High-Speed Phone Programming (This
command is for future use only.)
99# Exit Program Mode
To Next Page
Loading...