ZGEMMA STAR 2S User Manual

1.4 Conditional Access
Amongst the channels scanned via ZGEMMA-STAR 2Ssome channels can be properly tuned in only with the corresponding Smartcard and/
or CAM {Conditicmai Access Module). ZGEMMA-STAR 2S provides two Smartard Reader slots and one Condttkwial Interface slot Users need
to purchase those Smartcards and CAMs that are required for viewing such subscription based senrices.
Insertion of Smartcard
1 Open the door on the right side.
2 Insert Smartcard as in the following instruction with the IC chip pointing down.
3 Make sure that the Smartcard remain inserted while viewing.
5.2.7,6 Hard Disk Set Up
SMARTCARD
5.2.2 Service Searching
52,2,1 Tuner Configuration
1 5222Automatic Scan
[ O : MENU > Setup > System Settings > Hard drive > Hard
drive Setup]
You can set the duration of time after which HDD is to be put
into standby mode.
Here,you can choose from No standby to various duration.
Once you set this option, press GREEN key to confirm the
change.
[© : MENU > Setup > Service Searching > Tuner CcHiliguration]lf
you run the First Time Installation process, the Tuner A IB
is already configured.
1 O: menu > Setup > Service Searching > Automatic Scan]
The easiest way to scan services is to use Automatic Scan. In
the Automatic Scan menu, there are two options to choose
from as below.
•Clear Before Scan
YES is used when you want to delete the existing channel list
before you start the automatic scan. If you want to keep the
existing list, select NO.
•ScanTunerA(DVB-S2)
Press OK to activate the automatic scan. This will take some
minutes. As the scan proceeds, you will see the progressive
bar and the newly found services underneath.

ZGEMMA STAR 2S Specifications

General

Brand	ZGEMMA
Model	STAR 2S
Category	Receiver
Language	English