21
Calibration and Firmware Upgrade
SMOOTH-Q3 Firmware Upgrade
You can use "Zhiyun Gimbal Tools" or "ZY Cami" App to upgrade the firmware of
SMOOTH-Q3.
When upgrading the firmware, extend the SMOOTH-Q3 to ensure that there is
good contact with the contact points before performing the upgrade.
Method One:
1. Visit the official website of ZHIYUN (www.zhiyun-tech.com) , go to the
corresponding product page, click "Download", download the firmware and unzip.
Download the calibration upgrade tool and the USB drive and install. (USB drivers
are not required for Mac OS and WIN10 systems)
2. Connect SMOOTH-Q3 to the computer.
3. Power on SMOOTH-Q3 and enter standby mode.
4. Open "Zhiyun Gimbal Tools", click "Open", click "Firmware Upgrade". Click
"Browse" under "Path" to select the latest firmware downloaded (with the ".ptz"
file extension), and click "Upgrade" at the bottom to upgrade firmware. When the
firmware update completes, the SMOOTH-Q3 stabilizer will be turned off.
Method Two:
Connect the SMOOTH-Q3 stabilizer to the ZY Cami App. If the app prompts you to
upgrade the firmware, please tap to proceed with the operation. Internet connection
is required for the upgrade.
Before upgrading the firmware, please ensure that the SMOOTH-Q3 stabilizer
has more than 50% power remaining. You will not be able to exit the app
interface or access the back-end during the upgrading process. Pay attention to
the prompts on the app.
To Next Page
Loading...
Need help?
General
