24
control wheel to confirm. To set the power value, you can rotate the control
wheel. To complete the setting, press the control wheel to exit the interface, press
the Menu/Return button to save the settings and return to the previous menu.
When the display screen shows the “
√
” mark, the adjustment is complete.
3. Level
Three motor torque levels from low to high are provided based on the combined
weight of mainstream camera lenses available on the market. Users can select
the corresponding motor torque level according to the weight of their camera
and lens.
Operation steps:
Press Menu/Return button and rotate the fill light control wheel to select “Motor
torque” . Press the control wheel to enter the next menu and rotate the control
wheel to select “level”. Press the control wheel to enter the next menu, select
your desired level and press the control wheel to confirm. When the display
screen shows the “
√
” mark, the selection is complete.
How to Use
① When adjusting the motor torque, make sure that the lock switches of the
three axes on the gimbal are turned on, and the gimbal is upright and
placed on level ground.
② If a load is changed, please readjust the balance and adjust the power
values using the method mentioned above.
③ It is recommended to use auto-calibration first. If auto-calibration fails to
meet your requirements, you can use custom settings to fine-tune the
values. If the above two methods still do not meet your requirements, use
the level adjustment to select the power.
To Next Page
Loading...
Need help?
General
