Need help?Do you have a question about the ZIEHL-ABEGG UNIcon CPG-1000AVC and is the answer not in the manual?
General| Brand | ZIEHL-ABEGG |
|---|---|
| Model | UNIcon CPG-1000AVC |
| Category | Control Unit |
| Language | English |
Device is for measured value acquisition of differential pressures only.
Connect to terminals "+Us" and "GND", observe mains voltage tolerance.
Connect to terminals "A" and "GND", parallel control of EC fans.
For networking via MODBUS, connection at "A (D+)", "B (D-)", and "GND".
Explains how to choose the basic function of the device.
Configuration for pressure sensing and control modes.
Initial setup parameters for pressure modes.
Detailed settings for pressure control operation.
Configuration for volume sensing and control modes.
Initial setup parameters for volume modes.
Detailed settings for volume flow control operation.
Configuration for operating as a MODBUS slave device.
Sets device address and communication parameters for MODBUS.
Overview of MODBUS registers for data access and configuration.
Describes holding registers for device configuration and control.
Describes input registers for reading device status and measured values.
To Next Page
