ZIMO MX695 - Page 52

Page 52 Large-scale Decoder & Sound Decoder MX695/6/7/9
Value in CV #282 = time in tenth of a sec-
ond!
#283
Chuff sound
volume during full
acceleration
0 - 255
10
255
The volume of steam chuffs at maximum
acceleration is set with CV #283 (default:
255 = full volume).
If CV #281 = 1 (acceleration threshold set
to 1 speed step), the volume defined here
is applied with each speed increase, even
if it’s just 1 step.
LEAD
- CV
#284
Threshold for
deceleration
sound
0 -255
(internal
speed
steps)
1
1
Steam chuffs should be played back at
less volume (or muted) signifying the re-
duced power requirement during decel-
eration. The sound reduction logic is ana-
log to a reversed acceleration (per CV
#281 to #283).
= 1: Reduces sound to a minimum (as
per CV #286) when speed is reduced
by just 1 step.
= 2, 3 ... sound reduced to minimum after
lowering speed by this number of
steps.
#285
Duration of
reduced volume
during
deceleration
0 - 255
=
0 - 25
sec
10
30
=
3 sec
After the speed has been reduced, the
sound should remain quieter for a specific
time (analog to the acceleration case).
Value in CV #285 = time in tenth of a sec-
ond!
#286
Volume level
during
deceleration
0 - 255
10
20
CV #286 is used to define the chuff vol-
ume during deceleration (Default: 20 =
pretty quiet but not muted).
If CV #284 = 1 (deceleration threshold set
to 1 speed step), the volume defined here
is applied with every reduction in speed
(even if decreased by just 1 step).