Zinwell Powerline Ethernet Bridge User Manual

20
SPECIFICATIONS
Items Description
Powerline Ethernet Bridge device Powerline Ethernet Switch device
PHY Rate
200Mbps
Effect Data Rate
TCP: Up to 91 Mbps
UDP: Up to 94 Mbps
TCP: Up to 91 Mbps
UDP: Up to 93 Mbps
Frequency Band
2~28 MHz (With Mask)
Access Methods
CSMA/CA channel-access schemes
Qos
Four-level priority based contention access, and multi segment bursting
8-level VLAN priority field, TOS field
QoS Classification by destination MAC address and IP Port
Modulation
OFDM (QAM 8/16/64/256/1024, QPSK, BPSK, ROBO)
10/100 RJ-45 port
1 port 4 ports
Distance
AC Wire : up to 300 meters
LAN Standards
IEEE 802.3, IEEE 802.3U,
PLC Standard
HomePlug AV
Operating System
OS independent
Max. dev in a
network Group
Up to 63 slaves with 1 master, 64 total devices
IGMP
Support for IPv4/IGMP v1,v2,v3 snooping
Support for IPv6 and MLD v1,v2 snooping
Max 16 source addresses and Group Members
Encryption
128-bit AES Link Encryption with key management
LEDs
1. Power (green), 2. Powerline
Activity (green), 3. Ethernet
Link/Activity (green)
1. Power (blue), 2. Powerline
Activity (blue), 3. AV/1.0 DET (blue),
Temperature
0~40 ℃ (Operating); -20~60 ℃ (Storage)
10~85% Non-Condensing (Operating)
Relative Humidity
5~90% Non-Condensing (Storage)
Power Source
100 ~ 240 VAC 50/60Hz
Full load: (110 VAC) = 4.2W; (220 VAC)
= 5.3W; (240 VAC) = 5.8W
Power
consumption
Full load: (110 VAC) = 3.3 W; (220
VAC) = 3.8W; (240 VAC) = 4.2W
Standby mode
: Erp/Eup version:
(110 VAC) = 0.5W; (220 VAC) = 0.8W;
(240 VAC) = 0.9W
Non-Erp/Eup version: Less than 1.6
W for Europe/UK/US
Standby mode:
for 4 Eth port device
supporting standby, power consumption
is (110 VAC) < 1.0W; (220 VAC) < 1.7W;
(240 VAC) < 1.8W
Certification
CE, CE-LVD, FCC Class B, Rohs

Zinwell Powerline Ethernet Bridge Specifications

General

Brand	Zinwell
Model	Powerline Ethernet Bridge
Category	Switch
Language	English