Zip HYDROTAP G4 series - Advanced Options and System Reset

2120
USER MANUAL
805846UK - ZIP HYDROTAP G4 V1.00 NOV 2017
TECHNICAL SUPPORT TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
8.3.5 CO
2
purge (sparkling models only)
SECTION 8 LCD SCREEN
Caution must be observed when changing any settings within the
service menu as any changes may affect the normal operation of
the unit. This can only be done by a Zip technician. Please contact
your Zip service provider for further assistance.
• Press the [MENU] button for
main menu.
• Press the [Service] button.
• A password is required to enter
service menu.
!
8.4 Service
Note In UK call a licensed electrician / plumber,or call Zip on
0345 6 005 005, for assistance, service, spare parts or enquiries.
Fan speed adjustment
If the Command Centre is operating near 35
O
C or higher then the fan speed
must be 100%. The fan speed may be adjusted for quieter operation only if
the operating temperatures are considerably lower than 35
O
C.
• Press [MENU] for main menu.
• Press [Install] .
• Press [Advanced Options].
Use this screen to Enable or Disable
• The pump Anti Cavitation mode
• The Power Pulsing mode
• Adjust the fan speed to:
50% / 75% / 100%
8.3.7 Advanced options
• Press [MENU] for main menu.
• Press [Install] .
• Press [Reset] to power down and
restart the system. This is useful if you
need to reset a password in section
8.5.
8.3.8 Reset (restart)