To Next PageTo Next Page
Why is there a water supply failure in my Zip Water Filtration Systems?
If your Zip Water Filtration System isn't dispensing water, the first thing to check is whether the water supply is turned ON. Ensure that the water supply is properly connected and activated.
What to do if my Zip Water Filtration Systems shows condenser overtemp.?
If the condenser on your Zip Water Filtration System is overheating, it's likely due to a blocked air filter. Remove any blockage and clean the filter. You may also consult the user guide for detailed instructions.
How to fix a blocked condenser screen on a Zip Water Filtration Systems?
If the condenser screen of your Zip Water Filtration System is blocked, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and check the user guide for further assistance.
What to do if there is a water leak in my Zip Water Filtration Systems and I need to isolate the mains?
If you find your Zip Water Filtration System leaking water and need to isolate the mains, immediately turn off the mains water supply. Following this critical step, it's essential to call for service to address the water leak effectively.
What causes a hot tank to be under filled in Zip Water Filtration Systems?
If your Zip Water Filtration System's hot tank is under filled, it may be due to low water pressure. Check the water supply to ensure adequate pressure.
What to do if I see a water leak in my Zip Water System?
If you notice a water leak in your Zip Water System, immediately turn off the mains water supply. Then, call for service.
How to troubleshoot a power board fault in my Zip HydroTap G4 Water System?
If there's a power board fault in your Zip Water System, check the power supply and all fuses.
What to do if the condenser screen is blocked on my Zip HydroTap G4 Water System?
If the condenser screen is blocked on your Zip Water System, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and check the user guide for further instructions.
Why is the compressor over-running on my Zip HydroTap G4 Water System?
If the compressor is over-running on your Zip Water System, it might be too hot. Check the ventilation to ensure it's adequate.
What causes a condenser overtemp in Zip HydroTap G4?
If your Zip Water System is experiencing a condenser overtemp, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and consult the user guide.
General| Model | HydroTap G4 |
|---|---|
| Category | Water System |
| Power Supply | 220-240V, 50Hz |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Boiling Water Capacity | Up to 160 cups per hour |
| Filter | Advanced filtration system |
| Safety | Child safety lock |
| Filtration | 0.2 micron |
| Energy Efficiency | Energy-saving mode |
| Warranty | 5 years |
| Chilled Water Capacity | Varies by model (e.g., up to 175 cups/hour) |
