To Next Page
H
Harold HopkinsSep 5, 2025
What to do if my Zip Water Dispenser compressor is over-running?
- EEric HoldenSep 5, 2025
If the compressor in your Zip Water Dispenser is over-running, check the ventilation to ensure it's adequate.
What to do if my Zip Water Dispenser compressor is over-running?
If the compressor in your Zip Water Dispenser is over-running, check the ventilation to ensure it's adequate.
How to troubleshoot a power board fault in Zip Water Filtration Systems?
If your Zip Water Filtration System displays a power board fault, the issue might stem from an electrical disruption. To address this, check the power supply and all fuses connected to the system.
What to do if the boil dry protection is activated in Zip Water Filtration Systems?
If your Zip Water Filtration System's boil dry protection has activated, it's likely due to the safety mechanism being triggered. To reset, turn the power OFF and then ON again.
What causes condenser overtemp in Zip HydroTap G4 Water System?
If the condenser of your Zip Water System is experiencing overtemperature, this is likely due to a blocked air filter. Remove any blockage and clean the filter. Refer to the user guide for detailed instructions.
What does 'Power board fault' mean on a Zip Water Dispenser?
A 'Power board fault' on your Zip Water Dispenser indicates an electrical disruption. Check the power supply and all fuses.
What to do if there's a water leak in my Zip Water System?
If you detect a water leak, immediately turn off the mains water supply. You may also need to call for service.
What causes a condenser overtemp in Zip HydroTap G4?
If your Zip Water System is experiencing a condenser overtemp, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and consult the user guide.
Why is the hot tank under filled in my Zip Water System?
If the hot tank in your Zip Water System is underfilled, it could be due to low water pressure. Check the water supply to ensure it's sufficient.
What to do if boil dry protection is activated on my Zip Water System?
If the boil dry protection is activated on your Zip Water System, turn the power OFF and then ON again to reset it. This is usually triggered by a safety mechanism.
What to do if my Zip Water Filtration Systems shows condenser overtemp.?
If the condenser on your Zip Water Filtration System is overheating, it's likely due to a blocked air filter. Remove any blockage and clean the filter. You may also consult the user guide for detailed instructions.
General| Model | HydroTap G4 |
|---|---|
| Category | Water System |
| Power Supply | 220-240V, 50Hz |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Boiling Water Capacity | Up to 160 cups per hour |
| Filter | Advanced filtration system |
| Safety | Child safety lock |
| Filtration | 0.2 micron |
| Energy Efficiency | Energy-saving mode |
| Warranty | 5 years |
| Chilled Water Capacity | Varies by model (e.g., up to 175 cups/hour) |
