Page 10 of 16 801525 v3.05 09.20 HT C Com Install Instructions
Section 2
Ventilation
2.1 All Models
IMPORTANT: Proper air circulation must be provided. Allow a clearance envelope of 50mm either
side, and 200mm above the Command Centre. The system will operate correctly only if the recom-
mended clearances are provided.
It is recommended to install vent duct and louvre panels for under floor and /or door vent systems.
**Note: Inlet and outlet vents should be separated by a minimum of 100mm, to avoid hot air recirculation.
When installing air flow ducts, the following tools will be required:
•
Jigsaw and 12mm drill.
•
Keyhole or Wall Board saw.
Recommended Installation showing the correct air flow
**MIN. 100mm
Warm Air OUT
via kickboard louvre
MIN. 50mm
Cool Air IN via
cabinet floor,
front vent grille
To Next Page
Loading...
