801525 v3.05 09.20 HT C Com Install Instructions Page 7 of 16
WARNINGS
1. The Zip HydroTap unit must be earthed. The resistance of the earth connection
from each exposed metal part must be less than 1 ohm.
2. All Installation and service work must be completed by trained and suitably
qualified Tradespeople. Faulty operation due to unqualified persons working on
this product, or any other Zip product may void warranty coverage.
3. Plumbing and electrical connections must be made in accordance with local
regulations and relevant standards. In Australia and New Zealand: Plumbing
standard AS/NZS 3500 & Electrical Wiring Rules AS/NZS 3000.
4. This HydroTap product is rated for 230V 50Hz AC operation.
5. This unit must be installed with adequate clearances of 50mm on all sides, and
200mm above, to allow for air circulation. Additional means of ventilation is
critical if the vent kit, as supplied, cannot be fitted.
6. Flush water supply lines before any plumbing connections are made, to prevent
sediment from affecting operation.
7. The Command Centre must not be located near, or cleaned with water jets.
8. This product is designed for indoor use and must not be installed outdoors or
exposed to the elements of nature.
9. For safe operation, the HydroTap is designed to be installed, commissioned and
used within 48 hours. Should the HydroTap not be required for an extended
period of time (72 hours or more), do not fill and commission the HydroTap until
ready for first use.
10. For water taste and quality reasons, following any non-use period of more
than 72 hours, Zip recommends to perform a system flush. Failure to flush the
system may affect water quality.
11. Due to the process of continuous improvement, Zip Water reserves the right to
change details mentioned in this manual, without notice.
WARNINGS
!
To Next Page
Loading...
