Zip HydroTap G4 - Filter Maintenance; Dispense Times; Water Filter; To change the Filter: (See also Section C)

801912 - G4 BCS, BCSHA Commercial User Guide - July 2015 - v2.00 Page 23 of 28
To change the Filter: (See also Section C)
• Open the door of the under sink unit.
• Relieve system pressure via the filter flush stop cock, a quick open and
close will do. Use the bucket to catch the discharge.
• Grasp filter cartridge, depress the red lever at the top right of the filter and
rotate the cartridge a quarter turn to the left, then gently pull down.
Water Filter
The Zip HydroTap notifies when filter replacement is due. If you notice one of
the following, you will need to change the filter:
• The Change Filter light will flash white once a second and remain so until
reset.
• The filter percentage will show 0% on the Home screen.
Note: Depending on local water quality conditions and usage, the filter may
require changing anywhere from 500 Litres to 10,000 Litres. You may also
need to replace the filter if you notice unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement. Keep
a towel handy to dry up any drips.
Filter Maintenance
Dispense Times
This gives you the ability to change the maximum dispensing time. The
default settings for the maximum dispensing times is 15 seconds. Here,
the operator may change both the Boiling, Chilled and Sparkling water
dispensing times to between 5 and 15 seconds, in increments of 1 second.
LCD Screen operation - Section G
To edit the dispensing times:
1. Press [MENU] button for main
menu.
2. Press [Setting] button.
3. Press [Dispense Time] button.
4. Select the option to change and
scroll using the up and down
arrow Keys