Your Zip HydroTap will notify you when the filter replacement is due. The change filter light will flash white once per
minute until the filter has been replaced, and the filter percentage will show 0% on the Home screen.
Step 1:
Grab an empty bucket or container to collect the water which will be flushed through the system and an old towel to
mop up any spills.
Step 2:
Open the filter access door on the front of the HydroTap Command Centre. You will see the filter cartridge in front of
you.
Step 3:
Reach to the rear right hand side of the cartridge and you’ll find a flush line (looks like a hose) which is around 60cm
long which will be sealed with a stop cock located in the centre of the hose. Place the free end of the flush
line into the empty bucket or container. Turn the stop cock quickly on then off to relieve system pressure.
To Next Page
