4
Installation instructions & user manual
9120-25693 v3.00 Oct 2018 - ZIP CEX
Technical support
Tel: 0345 6 005 005 email: service@zipindustries.co.uk www.zipwater.co.uk
SAFETY INSTRUCTIONS
To observe additionally for pressureless installation:
• The water outlet behind the devices must not be blocked, and
the water flow must not be restricted.
• The water outlet facilities, such as shower heads must be
decalcified regularly. Deposits must be removed at regular
intervals.
• Only the fittings recommended by the manufacturer may be
used.
• If the appliance is exclusively connected to a single shower,
only the shower heads recommended by the manufacturer may
be used. No other fittings or appliances which decrease the
water flow to the shower may be installed.
been given supervision or ins truction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be performed by children without
supervision.
• If the appliance is factory equipped with a power supply cable,
it must be replaced with an original spare cable from the
manufacturer in case of damage by an authorised technician in
order to avoid any hazards.
• In accordance with EN 60335, the appliance must be
permanently connected to the supply through an isolating
switch with a contact separation of at least 3 mm in all poles
and be protected by a suitably rated RCD.
• The wall bracket must be secured with the supplied screws and
dowels. The appliance must be secured to the wall bracket.
The appliance may only be operated if it has been properly
mounted on the wall bracket.
• The required water resistance may not fall below the value
stated on the rating plate at any time.
To Next Page
Loading...
Need help?
General
