Zipro Nix User Manual

25
EN
TROUBLESHOOTING
CAUTION! Opening the housing of the device without a prior contact with a manufacturer’s service
voids the warranty. If you suspect a failure that requires the housing to be opened, contact manufacturer’s
service.
Error description
Possible causes
Solution
The device rocks to sides
The device was placed on an
uneven surface.
There is an object disrupting the
balance under the base of the
device.
Place the device on an even
surface.
Remove the object that upsets
the balance.
The bases have not be assembled
correctly.
Assembly the bases correctly.
Level the caps on the rear base.
Caps on the base have not been
installed and levelled correctly.
Assembly the rear base correctly.
Level the caps on the rear base.
The saddle sway
Bolts and knobs of the saddle
column have not been tightened.
Tighten the bolts and knob of the
saddle .
Noise during use
Incorrectly tightened elements.
Contact the manufacturer’s
service.
Slight humming noise may be heard during operation due to the
inertial movement of the flywheel caused by the nature of the
structure. It does not affect the operation of the device. Any possible
humming noises heard when rotating the pedals backwards occur for
technical reasons and have no negative consequences.
Noise and uneven operation
Bearings damaged.
Contact the manufacturer’s
service.
Lack of appropriate
resistance during training
Resistance adjustment cable
connected incorrectly.
Connect the cable correctly as
per the assembly manual.
Drive belt loose.
Contact the manufacturer’s
service.
The distance between
the flywheel and
the magnets increased.
Contact the manufacturer’s
service.
Voltage regulator
damaged.
Contact the customer service of
the manufacturer’s service.

Zipro Nix Specifications

General

Brand	Zipro
Model	Nix
Category	Home Gym
Language	English