ZIV 5EVM - Equipment Power Supply; Vehicle Power Supply; Pilot Wire (CP); Communication of the Recharging Points Network

5EVM-D · Electric Vehicle Home AC Charging Station
9
M5EVMD2011I
5EVM-D: Electric Vehicle Home AC Charging Station
© ZIV APLICACIONES Y TECNOLOGÍA, S.L.U. 2020
4.3.1 Equipment Power Supply
The power supply is represented in Figure 5 by the connector 1.
The power supply is provided by screw terminals, which offer great mechanical robustness.
These terminals allow cable sections of up to 25mm
2
.
The equipment has the following terminals from left to right:
L1. Phase R.
L2. Phase S.
L3. Phase T.
N. Neutral.
GND. Ground.
The number of terminals may vary based on the model of the recharge point, as it can be
single-phase or three-phase.
4.3.2 Vehicle Power Supply
The power supply cables and the IEC62196-2 hose ground, which is connected to the vehicle,
are screwed into the terminals shown in Figure 5 as connector 2.
The equipment, depending on the version, has the following terminals from left to right:
GND. Ground.
L1. Phase R.
L2. Phase S.
L3. Phase T.
N. Neutral.
4.3.3 Pilot Wire (CP)
Represented in Figure 5 as connector 3.
This terminal block is dedicated to the following:
Connection of the pilot wire (CP) of the hose according to IEC 62196-2.
The "Control Pilot" wire is used to regulate the demand of the EV by means of a PWM signal.
4.3.4 Communication of the Recharging Points Network
Represented as connector 4 in figure 5, two RJ11 connectors are available for RS-485
communication.
4.3.5 USB Port
Connector without assigned functionality.