ZKaccess TF1700 Installation Guide

27
TF1700 & ZKAccess CLASSIC 3.5 software INSTALLATION GUIDE
Tips for dierent ngerprint conditions
• ZKTeco’s ngerprint products are designed to verify ngerprints with highest
security irrespective of the conditions of the skin of the nger. However, in case
a ngerprint is not read on the sensor, please refer to the followings tips.
ū If a nger is stained with sweat or water, scan after wiping moisture o.
ū If a nger is covered with dust or impurities, scan after wiping them o.
ū If a nger is way too dry, please blow some warm air from your mouth on the
nger tip.
Tips for ngerprint enrollment
• In ngerprint recognition, enrollment process is very important. When enroll-
ing a ngerprint, please try to place the nger correctly with utmost care.
• In case of low acceptance ratio, the following actions are recommended.
ū Delete the enrolled ngerprint and re-enroll the nger.
ū Try another nger if a nger is not easy to enroll due to scar or cuts.
• In case of an enrolled ngerprint cannot be used due to injury or if the hand is
full, it is recommended to enroll more than two ngers per user.
Upright
Sideways
Skewed
Partial
DO NOT place the nger in the following positions
If a nger is placed
as shown on the left,
only a small area of
a nger is captured.
So it is recommended
to place a nger as
shown on page 24.

ZKaccess TF1700 Specifications

General

Brand	ZKaccess
Model	TF1700
Category	Controller
Language	English