DATA0
DATA1
GND
+12V
GLED
RLED
BEEP
Access Control Panel
IWD0
+12V
BEEP
GLED
RLED
IWD1
GND
IP Address：192.168.1.100
Subnet Mask：255.255.255.0
IP Address：192.168.1.124
Subnet Mask：255.255.255.0
Switch
…
Side View Back View
Tamper Magnet
Reset Button
485+ RS485+
485- RS485-
485+
485-
485+ 485-
RS485 Bus
485+ 485- 485+ 485-
RS485
10. Cautions:
6. Wiegand Output
The device supports standard Wiegand 26 output,
so you can connect it with most of the access control
7. Wiegand Input
connect with card reader. Theyan independent are installed each
The device has the function of Wiegand input upports to signal . It s
Wiegand signal extender in long distance or interference environment).
(2) To keep the stability of Wiegand signal, connect the device and the Access Control or Card Reader in same ‘GND’
(1) Please keep the distance between the device and Access Control or Card Reader less than 90 meters(Please use
There are two modes that the PC software communicate and exchange information with the device: RS485 and TCP/IP, and
supports remote control.
9. Communication
8.Other Functions
(1) Manual Reset:
(2) Tamper Function:
(A) Crossover cable: The device and PC connected
(B) Straight cable: The device and PC connected to
(2) TCP/IP Mode:
(1) RS485 Mode:
other restart it.abnormality, you can use ‘Reset’ function to
button hole with than 2mm).a sharp tool (the tip diameter less
Operation: Remove the black rubber cap, then stick the Reset
If the device does not work properly because of misoperation or
In device installation, user need to put a magnet between the device and
the back plate. If the device being illegally , and the magnet beingmoved
away from the device, it will trigger the alarm.
(2)We recommend the 3DC A/12V power supply. Please contact our technical staff for details.
(5)Please connect the ‘GND’ before all the other wiring especially under the environment with much electrostatic.
( )3 Please read carefully the terminal description and wiring by rule strictly. Any damage caused by improper
(4)Keep the exposed part of wire less than 5mm, to avoid unexpected connection.
(6)Do not change the cable type because of long distance between the power and the device.
(1)Power cable is connected after all the other wiring. If the device is working abnormally, please shut down the power
first, then make the necessary check . Kindly reminds you that any hot-plugging may damage the device, and
operations will be out of the range of our guarantee.
it is not included in the warranty.
Terminals PC Serial Ports
Converter
！
Warning: No operating with power on
in any case.
side of the door, to control the lock and access together.
Please use specified RS485 wire, RS485 active converter and
bus-type wiring.
Terminals definition please refer to the right table.
LAN/WAN through switch/Lanswitch.
Two ways for TCP/IP connection.
directly.
devices by now.
485+
485-
TXD
RXD
GND
GND
WD0
WD1
DATA0
GND
DATA1
(7) Please use specified RS485 wire, RS485 active converter and bus-type wiring. If the communication wire is longer than 100
meters, it is needed to parallel a terminal resistance on the last device of RS485 bus, and the value is about 120 ohm.
To Previous Page
Loading...
Need help?
General
