Need help?Do you have a question about the ZKTeco SF101 and is the answer not in the manual?
General| Brand | ZKTeco |
|---|---|
| Model | SF101 |
| Category | IP Access Controllers |
| Language | English |
Details device features, specifications, and parameters like power, memory, and communication interfaces.
Describes the front, back, and bottom panel components, including LED, keys, fingerprint reader, and connection ports.
Provides important precautions and guidelines to follow before and during the installation process for optimal performance and safety.
Details the steps and methods for physically installing the device, including mounting and wiring procedures.
Illustrates the overall system setup and connections between the device and peripheral components like locks, sensors, and alarms.
Explains how to connect the SF100/SF101 to an access controller using Wiegand output modes.
Details the wiring and connection methods for both NC (normally closed) and NO (normally open) door locks.
Covers connecting external devices like exit buttons, alarms, doorbells, and door sensors to the system.
Specifies the power requirements and connection instructions for the device, including voltage and current ratings.
Guides users through the process of enrolling an administrator, which is required before enrolling normal users.
Explains how to enroll individual users by fingerprint or card, with a user ID range of 1-999.
Details the steps and flow for authenticating users via fingerprint or card to gain access.
Outlines the procedure for deleting a single user from the system, including administrator confirmation steps.
Describes the process for clearing all enrolled users and administrators from the system.
Explains the detailed sub-flows for fingerprint enrollment and overtime judgement during operations.
Explains how to establish communication between the device and a PC using the RS232 serial port.
Details RS485 communication setup for networking devices and remote management via RS485 bus.
Describes how to connect and communicate with the device using a USB cable for data upload and parameter settings.
To Next Page
