26
Troubleshooting
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The
dishwasher won’t start
The door may not be
closed properly.
Make sure that the door is
closed and latched.
The power is off or
not connected.
Make sure that the
power is connected
and turned on.
The delay start option is selected.
Refer to the “Delay” section
under "Controls and
Indicators" on page 9.
The dishwasher beeps
at the end of the cycle
This is normal and indicates
that the wash cycle is complete.
This is a normal occurrence.
The rinse
aid light is on
The rinse aid level is low. Add rinse aid.
The dishwasher
runs too long
The dishwasher is connected to a
cold water supply.
Make sure that the
dishwasher is connected to
a hot water supply. If not,
change the water supply to
a hot water source.
The cycle time varies, depending
on the soil level of the dishes.
When heavy soil is
detected, the wash times
will be longer.
Depends on the option selected.
Some options will add time
to the cycle.
The dishes are not
drying enough
The rinse aid dispenser is empty
or the setting is too low.
Fill the rinse aid dispenser.
Increase the rinse
aid setting.
Dishes are loaded improperly.
Reload the dishwasher
as shown in "Preparing
and Loading
Dishes" on page 9.
The cycle you chose did not
include drying.
Choose a cycle
with drying.
TROUBLESHOOTING
To Next Page
