12
INSTALLATION
INSTALLING THE LEGS
The ranges must be used with the legs properly installed. Height-adjustable legs are shipped
with the range in a foam container above the range. Legs are 4" (102 mm) tall and can be
adjusted up to 2 1/2" (64 mm) for a maximum height of 6 1/2" (165 mm).
Installing the Legs
4" (102 mm)
Before installing the legs, position the appliance near its final location, as the legs are not
suitable for moving the appliance over long distances.
1. After unpacking the range, raise it enough to insert the legs in the appropriate receptacles
situated on the lower part of the appliance. Lower the range gently to keep any undue
strain from legs and mounting hardware.
2. Adjust leg height to the desired level by twisting the inside portion of the leg assembly
until the proper height is reached. Check with a level that the range is perfectly level.
INSTALLING THE SQUARE COVERS
Some ranges come with attachable square leg covers. To install, loosen the round leg from
the range to accommodate for the square leg. Align the top of the square leg (with the slit)
to the top of the round legs and slide in. Adjust the square leg and the round leg until they
are flush with the ground.
NOTE: If the range is not level, the cooking will be uneven. When adjusting the legs, ensure
they are the same height.
Installing the Legs
To Next Page
Loading...
Need help?
General
