40
PREPARING FOR PLACING THE REFRIGERATOR INTO THE CABINET
• Before preparing to push the unit into the cabinet cutout, run the water line hose through the
rear channel of the refrigerator (below image, right circle) to the front of the unit (below,
left). You can optionally tape the water line to the floor to avoid it getting tangled during
installation.
• Plug in the refrigerator to make sure the power is working and that the display has
been activated.
WARNING
The plug of the product must be accessible after installation. If the plug is not
accessible after installation, the power must be cut off from the main switch.
i
You can use tape or other protective items you think are necessary to protect
the edges of the cabinet furniture when placing the product.
INFO
Preparing the Water Line
INSTALLATION
To Next Page
Loading...
