Zmorph VX - Occupational Hygiene; Electrical Safety and Risk

Set the printing temperature
to the PLA material., Nozzle
200 0C, Bed 60 0C.
If your lament is not loaded,
feed it using arrows on the
screen. If your lament is
already loaded choose “Next”.
Wait for the machine to
nish printing pattern.
Choose “Calibrate”.
Take the calibration cable
and connect wider end to the
RIGHT frame socket.
Connect the narrow end
of the calibration cable to
X-carriage B socket.
Choose “Maintenance”.
Choose “Auto 3-point”. Wait
for the machine to heat up
and nish the probing.
To ensure best calibration
result print calibration
pattern. Choose “Start”.
1
4
7 8 9
2
5
3
6
Autocalibration