Congratulations, you just
started your rst print.
Apply 3D printing adhesive to
the center of the worktable.
Two layers should be
enough.
Choose “New Job” from the
LCD touchscreen.
Select the Astronaut le to
print. It is located in
“INTERNAL -> EXAMPLES ->
SINGLE EXTRUDER” folder.
Wait until the printer heats up
automatically.
Choose “Prepare Bed”.
Attach the cooling fan to the
X-carriage. Remember, when
printing with PLA always use
cooling fan.
Click “Play” to start printing.
1
4
8
6
2
5
3
7
First print
To Next Page
Loading...
