Do you have a question about the Zmorph FAB and is the answer not in the manual?
Build Volume | 250 x 235 x 165 mm |
---|---|
Nozzle Diameter | 0.4 mm |
Filament Diameter | 1.75 mm |
Print Speed | up to 100 mm/s |
Software | Voxelizer |
Dimensions | 530 x 555 x 480 mm |
Layer Resolution | 0.05 - 0.3 mm |
Connectivity | USB, Ethernet |
Supported Materials | PLA, ABS, PETG, TPU, Nylon |
Power Supply | 24V DC |
Print Technology | Fused Filament Fabrication (FFF) |
Extruder Type | Single Extruder |
Display | 5-inch capacitive touchscreen |