zmorph3d.com 11
Setting up Zmorph Fab
6.1 Unboxing
6.2 Safety features removal
remove the belt clips from the toolhead and the protective foam from the worktable.
Gently cut the tapes and open
Zmorph Fab box.
Take out all containers with
accessories from the box.
Take out Zmorph Fab from the
box. Remove side protective
foams and foils.
Open the front cover of the
machine to the point where it
touches with the back cover.
Magnetic latches will keep
the cover open.
Remove the protective tool
band.
Gently remove the work table
protection foams.
6. Setting up Zmorph Fab
To Next Page
Loading...
