Zmorph FAB User Manual

Zmorph Fab - QUICK START GUIDE 10
Location requirements
5. Location requirements
After unpacking, place the machine in a suitable location.
 
 Do not cover the machine with any materials during operation.
 The machine should not be exposed to moisture.
 
 Do not use extension cords.
 Leave a 20 mm (minimum) space from the wall, for proper ventilation.
 

 It is recommended that the room in which the machine is located should be well ventilated, as
hazardous vapors may escape from the machine during operation.
550 mm
min.
50mm
550 mm
750 mm 750 mm

min.


Zmorph FAB Specifications

General

Build Volume	250 x 235 x 165 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Print Speed	up to 100 mm/s
Software	Voxelizer
Dimensions	530 x 555 x 480 mm
Layer Resolution	0.05 - 0.3 mm
Connectivity	USB, Ethernet
Supported Materials	PLA, ABS, PETG, TPU, Nylon
Power Supply	24V DC
Print Technology	Fused Filament Fabrication (FFF)
Extruder Type	Single Extruder
Display	5-inch capacitive touchscreen