Zmorph FAB User Manual

zmorph3d.com 25
9.3 First Print

Choose ‘’. Choose ‘CHOOSE FILE’. Files uploaded to the internal
card are located in the

to the SD card are located in
the ‘EXTERNAL’ tab.
Select the previously prepared

select its name.
Exiting the folder is done
by selecting the folder icon.

choose ‘NEXT’.
NEW JOB MAINTENANCE
CANCEL NEXT
EXTERNAL
INTERNAL
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
CANCEL NEXT
EXTERNAL
INTERNAL
CANCEL NEXT
EXTERNAL
INTERNAL
CANCEL NEXT
EXTERNAL
INTERNAL
example.gcode
example.gcode example.gcode example.gcode
NOTE

will automatically start preheating.
The table can be prepared by
selecting ‘’. Apply
an adhesive solution to the
table surface.
Choose ‘START’. 
when the extruder and the
table have reached the right
temperature.
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
PAUSE
ABORTSETTINGS
example.gcode
progress 20% 0h34m elapsed
Dual Extruder Toolhead

Zmorph FAB Specifications

General

Build Volume	250 x 235 x 165 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Print Speed	up to 100 mm/s
Software	Voxelizer
Dimensions	530 x 555 x 480 mm
Layer Resolution	0.05 - 0.3 mm
Connectivity	USB, Ethernet
Supported Materials	PLA, ABS, PETG, TPU, Nylon
Power Supply	24V DC
Print Technology	Fused Filament Fabrication (FFF)
Extruder Type	Single Extruder
Display	5-inch capacitive touchscreen