Zmorph Fab - QUICK START GUIDE 24
NOTE
being the result of the automatic calibration process.
Choose ‘NONE’ option. Tap the ‘NEXT’ button.
line is closest to the best
tap ‘NEXT’.
lines lower or upper according
to your choice. Each line is
printed 0.05 mm lower/upper
according to user choice.
‘NEXT’.
Calibration complete.
Choose the best printed line
(numeration from le to right)
1 2 3 4 5
NEXT
NONE, REPEAT PRINTING
Choose the best printed line
(numeration from le to right)
1 2 3 4 5
NEXT
NONE, REPEAT PRINTING
Which line was better?
1 5
NEXTBACK
NONE, REPEAT PRINTING
1 2 3 4 5
NEXT
Choose the best printed line
(numeration from le to right)
Calibration complete!
DONE
Dual Extruder Toolhead
NOTE
If after the second round of calibration the user still decides
that none of the lines are accurate, the machine will show a
warning screen and advise to repeat the automatic calibration
process or to perform the manual calibration.
If meeting calibration issues or autocalibration doesn’t work,
please contact Technical Support.
Calibration
result inaccurate
REPEAT
MANUAL
BACK
To Next Page
Loading...
