Zodiac CX35 - Getting Started

Section 2. Getting Started
2.1 GeneralSpecications
The general specications for the cleaner are as follows:
Control box
supply
voltage
220-240 VAC, 50 Hz; short circuit-proof
safety isolating type
Supply voltage 30 V DC
Installed load 150 W max
Cable length 15m (50 ft)
Cleaner size
(WxDxH)
41 x 42 x 25 cm
Weight of Cleaner 9 kg
Filtration All-purposeltercanister
Cycle lengths Variable programming
The cleaner power supply is double-insulated. A
double-insulated electrical appliance is one which has
been designed in such a way that it does not require a
safety connection to ground. Therefore, devices having
double-insulated construction, such as this cleaner, do
not require a grounded (three-prong) plug.
2.2 Recommendations for Use
• When the pool is dirty, remove the largest
debris using a net in order to optimise cleaner
performance.
• Remove any thermometers, toys, and other objects
that might damage the cleaner.
• The cleaner must operate in pool water with the
following characteristics: chlorine < 3 ppm;
pH 6.8 - 7.6; temperature 15° C - 35° C.
• Fully submerge the cleaner before beginning the
cleaning cycle.
• Start by launching several Floor only mode cleaning
cycles.
• Never cover the control box while the cleaner is in
operation.
• You can operate the filter pump during a cleaning
cycle; any particles in suspension will be filtered
out. However, it is advised to start cleaning with the
filter pump off.
• If part of the pool is not cleaned properly, change
the launch point of the cleaner.
• Launch the cleaner with enough floating cable
to cover the widest distance of the pool to avoid
tangling.
• An average three cycles per week of the cleaner
means your pool will always be clean and the filter
less clogged.
2.3 Unpacking
The packaging should contain the following items:
• Robotic cleaner and floating power cable
• Control unit with power cord
• Transport and storage caddy assembly components
(Figure 1)
(a) handle frame
(b) support blocks (x 2)
(c) wheels (x 2)
(d) wheel locking clips (x 2)
(e) wheel axle / hubcap (x 2)
(f) base unit
(g) caddy handle
A
x 2
B
C
D
x 2
x 2
E
x 2
F
G
Figure 1. Transport Caddy Assembly
Components
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage during
transport.
• If there are missing parts or damage, contact
Zodiac Technical Support: 1300 763 021
4
H0574000_REVA