5
1.5. BAD ADHESION TO POOL BOTTOM
The robot doesn't stay properly on the bottom of the pool, and even wants to pull away from the
bottom.
POSSIBLE CAUSES
CHECKS AND CORRECTIVE ACTION
- The robot is too light because there's
air in it.
- The rotor is broken or obstructed by
foreign bodies.
- The robot's suction system is
malfunctioning.
Æ Turn the robot over to expel the air from the filter
bag and press the foam pads.
Æ Add more ballast.
Æ Remove any hairs, pieces of cloth or foreign
bodies obstructing the rotor or replace the rotor if it
is broken.
Æ Bring the robot up to just below the water level
and check for backflow at the turbine screen outlet.
If the pump isn't working, remove the motor unit and
ask your supplier for the necessary after-sales
service.
1.6. NO MOVEMENT – SUCTION OK
The Indigo won't go forwards or backwards, but the suction system is working properly (backflow at
turbine outlet).
POSSIBLE CAUSES
CHECKS AND CORRECTIVE ACTION
- The belts are slack.
- The beta pin has come out of its housing
and fallen into the motor unit protective
screen or into the robot.
- The belts and tracks are slipping (fatty
bodies present).
- The traction motor is malfunctioning.
Æ Tighten the belts or replace them.
Æ Change and refit the pin.
Æ Clean the tracks, belts and pulleys with C
essence or similar.
Æ Ask your supplier for the necessary after-sales
service.
To Next Page
Loading...
