7
2. ASSEMBLY / DISASSEMBLY
2.1. T
OOLS REQUIRED
∗ No-bounce mallet
∗ Cordless drill/screwdriver
∗ Flat-nose pliers
∗ Wrench ∅ 19 (packing gland)
∗ Automatic stripping pliers
∗ "Ogival head" oblique cutting pliers
∗ Lever-operated grease pump
∗ Set of screwdrivers for slotted-head screws
∗ Set of screwdrivers for cross-recessed screws
2.2. BRUSHES
2.2.1. Your robot is fitted with foam pads.
We recommend that you change the foam pads after one season's use.
It is essential to change them if their surface becomes smooth or worn
Turn the robot upside down and:
Open out the pads to reveal the foam attachment clips, then lift the clips up (using a lever if
necessary) and remove them; be careful not to open them too wide. (Zoom A).
Diagram 16
To Next Page
Loading...
