Zodiac MilPro ERB 310 - Page 11

10/16
NOTICE
IF THE CAPS ON THE OVER PRESSURE VALVES HAVE BEEN
REMOVED WHILE THE BOAT IS NOT IN USE, THEN ANY
INCREASE IN PRESSURE WILL HAVE BEEN CONTROLLED AND
NOT EXCEEDED THE PRESSURE LIMITS.
IF NOT, THEN THE PRESSURE MUST BE REDUCED BY LETTING
AIR OUT THROUGH THE INFLATION VALVES.
Buoyancy tube inflation valve
-
A
• Remove the cap,
• Release some air by lightly pushing
down on the diaphragm
• Screw on the cap.
A
High pressure floor inflation valve
-
B
• Remove the cap,
• Release some air by lightly pushing
down on the diaphragm (1) with a blunt
object (such as a pen), CAUTION:
MAKE SURE THE DIAPHRAGM
DOES NOT FOLD OVER.
• Screw on the cap.
B
1