Zodiac MilPro ERB 310 - Boat Assembly

Assemble the boat on a smooth clean surface.
IF THE BOAT IS STORE
UNFOLDING, LET
TEMPERATURE, 20°C.
ASSEMBLING
THE HIGH PRESSURE
• Place the deflated
floor at the bottom
of the boat; and
make sure the
deflated floor is
correctly placed in
the corner
reinforcements.
• Tighten the
buoyancy tube /
floor and
transom/floor
fixation buckles.
Lace the high
pressure floor to the
fabric flap at the bow
5
/
16
BOAT ASSEMBLY
Assemble the boat on a smooth clean surface.
IF THE BOAT IS STORE
D AT A TEMPERATURE B
ELOW 0°C, BEFORE
UNFOLDING, LET
IT WARM UP FOR 12 HO
URS AT ROOM
TEMPERATURE, 20°C.
THE HIGH PRESSURE
FLOOR
Securing the floor to the
transom:
Slide the after line into the
batten’s groove.
ELOW 0°C, BEFORE
URS AT ROOM
Securing the floor to the
Slide the after line into the