H0396500.A3.EN–2013‐01 4
Disconnect the cleaner from the power supply box before cleaning or carrying outmaintenance on the
cleanerandcontrolunit.
Thecleanerisfittedwithasafetydevicethatautomaticallyswitchesoffthecleanerifitstartsoutsidethe
water.Forpoolswithanimmersedbeach,thissystemmakesitpossibleforthecleanertomakea180°turn
toreturnintothewater.
3.5.REMOVALFROMTHEPOOL
•Attheendofthecleaningcyclethecleanerstopsandthelightonthecontrolunitstaysonforapproximately
15minutes.Thisperiodisthetimethatthemotorneedstocoolandthereforeavoidsdamagetothecleaner.
•Whentheindicatoristurnedoff,gentlypullonthefloatingcable
toapproachthecleanertothesideofthe
pool(1).
• Only lift the cleaner from the water using the
handle(2).
•Letthewaterdrainawaybykeepingthecleaner
vertical.
•Disconnecttheelectricplugfromthecontrolunit
anddisconnectthecontrolunitcable.
• At the end of each cycl
e, roll the cable starting
from the cleaner towards the connector.Make
sure that the cable is disentangled on its entire
length.
MAINTENANCE
4.1.CLEANINGTHEFILTERANDTHEAPPLIANCE
•Aftereachcycle,rinsethefilteranditsholderinclearwater.
• The cleaner must be cleaned regularly using slightly soapy or clean water, do not use solvents such as
trichloroethyleneoritsequivalent.Rinsethecleanergenerouslyusingcleanwater.
Donotletyourcleanerdryinthesunbythepool.
4.2.FITTINGTHEFILTER
•Placethefilterhooksonthesmallshaftstotherearofthecover(1)
•Pushbackthefilterandlockitusingthefrontclip(2).Ifthefilteriscorrectlyfittedtothecoveritshouldnot
fallwhenyouholditusingthecoverhandle.
•Fitthehingesoverthee
dgesattherearofthecleanerbody(3).
•Pushbackthecoverandlockitusingthefrontclip.Gentlyliftthecleanerusingthehandletomakesurethe
coveriscorrectlyfitted.
To Next Page
Loading...
