What to do if the Zodiac Ultrasonic Jewelry Cleaner control box does not respond?
If your Zodiac Ultrasonic Jewelry Cleaner control box isn't responding, try unplugging the power cord from the mains socket, waiting 10 seconds, and then plugging it back in.
How to fix if part of the pool is not correctly cleaned by Zodiac Ultrasonic Jewelry Cleaner?
To address this issue with your Zodiac Ultrasonic Jewelry Cleaner, repeat the immersion steps, and try different locations in the pool until you find the right spot.
Why Zodiac Ultrasonic Jewelry Cleaner does not climb pool sides?
If your Zodiac Ultrasonic Jewelry Cleaner isn't climbing the pool sides as well as it used to, it could be due to several reasons. The filter might be full or clogged, so try cleaning it with fresh water. If it's severely blocked, use an acid solution like spirit vinegar. Replace the filter if necessary. Also, check if the tires are worn and replace them if needed. Microscopic algae may be present, requiring shock chlorination and a slight reduction in pH, but remove the appliance during shock treatment. Finally, inspect the brushes for wear and replace them if necessary.
How to stop Zodiac Ultrasonic Jewelry Cleaner cable from tangling?
To prevent the Zodiac Ultrasonic Jewelry Cleaner cable from tangling, avoid unrolling the entire length of the cable into the pool. Place only the necessary length in the pool and spread the rest along the side.
Why Zodiac Ultrasonic Jewelry Cleaner does not stay on pool bottom?
If your Zodiac Ultrasonic Jewelry Cleaner isn't staying firmly on the pool bottom, it might be due to air trapped inside. Repeat the immersion steps to remove any air. Another reason could be a full or clogged filter; clean it with fresh water or an acid solution like spirit vinegar, and replace it if needed. Also, inspect the propeller for damage.
What to do if Zodiac Ultrasonic Jewelry Cleaner does not move?
If your Zodiac Ultrasonic Jewelry Cleaner isn't moving upon start-up, first ensure the control box's power socket is receiving power. Also, verify that a cleaning cycle has been initiated and that the lights are on.
General| Pool Type | In-ground |
|---|---|
| Warranty | 2 years |
| Power Source | Electric |
| Cleaning Path Width | 11 inches |
| Suitable For | Residential pools |
To Next Page
