Zodiac VORTEX-PRO VX45 4WD - Operation; General Operation Cautions and Tips

Figure 13. Remove Protective Cap
Figure 14. Connect Power Cable
2. Gripthenotchedendoftheoatingpower
cable, insert into the control box, and turn
clockwise to tighten. (Figure 14.)
NOTE: Toavoiddamagingthepowercable,donottryto
twisttheentIrecablehousing(seebelow).
NOTE: Toavoidexposingthepowercableconnectorpins
towater,besuretheconnectorisscrewedinallthe
wayandthereisnogap.(seebelow).
Section 4. Operation
CAUTION
Topreventdamagetothecleaner,besuretoadhere
tothefollowingguidelines:
• Removethecleanerfromthepoolafterthe
cleaningcycleiscompletedandstoreonthecaddy
outofdirectsunlightorinclementweather.
• ForVX40andVX454WDmodelswherecaddy
isnotincludedinthepack,storethecleanerout
ofdirectsunlightorinclementweather.Storethe
controlboxonthebaseasshowninFigure12.
• Neverliftthecleaneroutofthepoolbythefloating
cable.Alwaysusetheliftfeaturetoremovecleaner
fromthepool.
• Takeadditionalcarewhenliftingthecleaneroutof
thepool.Itbecomesheavierwhenfilledwithwater.
• Alwaysremovethecleanerfrompoolwhensuper
chlorinatingoraddingacid.
• Donothandlecleanerwhileitisinoperation.
IMPORTANT
• Alwaysmakesurethecleanerheadisfully
submergedbeforeyoubeginoperation.
• Cleanthefiltercanisteraftereachcleaningcycle.
• Donotleaveyourcleanerinthepoolona
permanentbasis.
• Attheendofeachcycle,removethecleanerfrom
thepool.Startatthecleanerheadanduntangleany
coilsinthecablebeforestoringthecleaner.
H0516700_REV C
8