Need help?Do you have a question about the Zodiac Z2 and is the answer not in the manual?
Indicates system status: disarmed, low power, armed, or triggered alarm.
Shows GSM network status: searching, normal signal, or connection mode.
Instructions to store phone numbers for SMS notifications and alarm alerts.
Guide on how to change the control panel's system language for SMS.
Instructions on how to arm and disarm the security system.
Control panel calls pre-stored numbers when an alarm is triggered.
Dial the panel and use voice commands to control the system.
Sensors in this zone do not trigger alarms when system is armed in Home Mode.
Allows entry/exit delays, suitable for door/window contacts.
Sensors trigger the siren when the system is armed.
Sensors trigger alarms regardless of system armed status.
Instructions for saving phone numbers to receive SMS alerts.
Send '0' via SMS to disarm the alarm system.
Send '1' via SMS to arm the alarm system.
Send '2' via SMS to set the system to Home Mode.
Send '00' via SMS to query current system settings.
Send '5' via SMS to manage stored phone numbers.
Send '91~99' via SMS to rename zones 1 to 9.
Receive SMS notifications for low battery status of accessories.
Receive SMS notifications for tamper alarms from accessories.
Configure entry/exit delay times using SMS commands.
Configure siren volume and ringing duration via SMS.
Set a new disarm password using SMS commands.
Define the number of times the panel rings before answering a call.
Set how many times the system redials if the user doesn't answer.
Remove all paired wireless accessories from the system.
Switch the system's language using specific SMS codes.
Reset the system to its default factory configuration.
Press the arm button to arm the system; LED indicates status.
Press the disarm button to disarm the system; LED indicates status.
Activate Home Mode to arm regular zones while disarming home mode zones.
Pressing the SOS button triggers an alarm and sends notifications.
Pairing the remote control with the control panel.
Describes LED behavior for self-testing, intruder detection, and low voltage.
Explains sensor operation, self-testing, and power-saving standby mode.
Instructions for pairing the motion detector with the control panel.
Recommendations for mounting the motion detector for optimal performance.
Steps to test the motion detector after installation to ensure it works.
Instructions for mounting the door/window contact transmitter and magnet.
Pairing the wireless door/window contact with the control panel.
Common issues and their solutions for the alarm system.
Important safety guidelines for optimal product use and lifespan.
Information regarding WEEE and RoHS directives compliance.
General| Brand | Zodiac |
|---|---|
| Model | Z2 |
| Category | Security System |
| Language | English |
To Next Page