6
#logfile configuration
logfile /etc/ppp/ppp-logfile
record /etc/ppp/ppp-dumplog
#call to chat script
connect '/usr/sbin/chat -v -f /etc/chatscripts/lte_dial'
7 The second script lte_dial should be placed into the directory
/etc/chatscripts/ The contents of that script are below:
#abortstring
ABORT BUSY
ABORT VOICE
ABORT "NO CARRIER"
ABORT "NO DIALTONE"
ABORT "NO DIAL TONE"
ABORT "NO ANSWER"
ABORT "DELAYED"
ABORT "ERROR"
#ispnumber
"" AT
TIMEOUT 12
OK ATH
OK ATE1
#ispconnect
OK ATD*99#
TIMEOUT 22
CONNECT ""
8 To connect to the Internet, enter the command pppd file
/etc/ppp/peers/zdial. Once connected, you can try pinging a known
website. If it works, Congratulations! Your installation is complete. If
your modem is NOT working, please see Troubleshooting your
Internet Connection below.
Note: If you are already connected to the Internet using the Ethernet
port of your Raspberry Pi, remove the Ethernet cable to use the USB
modem. If you are connected to the Internet through Raspberry Pi’s
WiFi port, you can disconnect from this connection by bringing the
WiFi interface down with the command ifconfig wlan0 down.
To disconnect your USB modem connection, press ctrl-c
Once you have established the connection, you may consult the full-length
user manual at www.zoomtel.com/4630support for more detailed help on
using the modem with your specific application.
To Next Page
Loading...
Need help?
General
