06
Using the POWER/HOLD switch and turning the power on/off
Left side
POWER/HOLD
switch
1
Turn all connected
equipment off rst.
2
Insert an SD card.
3
Slide the POWER
switch to turn the
power on and start up.
4
Turn connected
instruments and
monitoring equipment
on in that order.
Turning the power on and starting up
NOTE:
• Before turning the power on, lower the
volume of instruments and monitors
connected to the H4n Pro.
• If
the display
reads
“No Card” when
starting up, make
sure that an SD
card is inserted
correctly.
• If the display says “Reset DATE/TIME”
when starting
up, the date and
time have been
set to their default
values.
HINT: Turning multiple devices on
When many devices are connected, turn
them on in the following order.
Instruments
H4n Pro
ON ON ON
ON
Mixer Amp
To Next Page
Loading...
