2 3
Flanger This is a jet sound like an ADA flanger.
Knob1 Knob2 Knob3
Page01
Depth 0–100 Rate 0–50
Reso -10–10
Sets the depth of the modulation. Sets the speed of the modulation.
Adjusts the intensity of the modulation resonance.
Page02
PreD 0–50 Mix 0–100 Level 0–150
Sets pre-delay time of effect sound.
Adjusts the amount of effected sound
that is mixed with the original sound.
Adjusts the output level.
Effect Types and Parameters
[DYN/FLTR]
Comp This compressor in the style of the MXR Dyna Comp.
Knob1 Knob2 Knob3
Page01
Sense 0–10 Tone 0–10 Level 0–150
Adjusts the compressor sensitivity. Adjusts the tone. Adjusts the output level.
Page02
ATTCK Slow, Fast
Sets compressor attack speed to
Fast or Slow.
RackComp This compressor allows more detailed adjustment than Comp.
Knob1 Knob2 Knob3
Page01
THRSH 0–50 Ratio 1–10 Level 0–150
Sets the level that activates the
compressor.
Adjusts the compression ratio. Adjusts the output level.
Page02
ATTCK 1–10
Adjusts the compressor attack rate.
SlowATTCK This effect slows the attack of each note, resulting in a violin-like performance.
Knob1 Knob2 Knob3
Page01
Time 1–50 Curve 0–10 Level 0–150
Adjusts the attack time.
Set the curve of volume change during
attack.
Adjusts the output level.
Page02
ZNR
ZOOM's unique noise reduction cuts noise during pauses in playing without affecting the tone.
Knob1 Knob2 Knob3
Page01
THRSH 1–25 DETCT GtrIn, EfxIn Level 0–150
Adjusts the effect sensitivity. Sets control signal detection level. Adjusts the output level.
Page02
LineSel
Sound input into the LineSel effect is sent directly to the OUTPUT jacks when OFF and to the next
effect in order when ON.
Knob1 Knob2 Knob3
Page01
EFX_L 0–150 OUT_L 0–150
Adjusts level sent to next effect.
Adjustslevelsentdirectlytothe
outputs.
Page02
Effect type Effect explanation
Parameter
Parameter range
Effect screen
Tempo synchronization possible icon
Parameter explanation
Effect Types and Parameters
To Next Page
Loading...
Need help?
General
