Zoom Pro 4040 - Delay Module: Mono and Ping-Pong Types; Reverb Module: Effect Types and Parameters

■ Effect Module 4: Delay
This effect module adds an echo component to the direct
sound. You can choose between simple monaural delay and
stereo ping-pong delay. It is also possible to change the
delay time by tapping the BANK ▲ pedal. For details
regarding tapping input, please refer to page 23.
Digital delay with a delay time of up to 1000 milliseconds.
Explanation
(1)DELAY TIME (x100 ms): This parameter adjusts the
delay time (interval between delayed sounds) in 100-ms
steps.
(2)DELAY TIME (x1 ms): This parameter adjusts the
delay time in 1-ms steps. The sum of parameters (1) and
(2) becomes the final delay time. When parameter (1) is
10 (= 1000 ms), parameter (2) is fixed at 0 (zero).
(3)FEEDBACK: Determines the number of repetitions of
the delay sound. The higher the value, the more
repetitions are added.
(4)MIX: Determines the balance between effect sound and
direct sound. At a setting of 0 (zero), the output signal
contains only the direct sound, and at a setting of 10 only
the effect sound.
This is a ping-pong type delay where the delayed sound
alternates between the left and right channel.
When the 4040 is used in a monaural configuration,
only short delay signals are output from the
OUTPUT L/MONO jack.
■ Effect Module 5: Reverb (REV)
This effect module includes three types of reverberation
effects.
This effect simulates hall-type reverberation, adding rich
ambience to the sound.
Explanation
(1)TIME: Determines the duration of the reverberation.
Higher values increase the reverb time and the apparent
room size.
(2)TONE: Determines the tonal quality of the reverberation.
The higher the value, the brighter the sound.
(3)MIX: Determines the balance between effect sound and
direct sound. At a setting of 0 (zero), the output signal
contains only the direct sound, and at a setting of 10 only
the effect sound.
This is a short, room-type reverb effect, which is suitable to
add backing to a simple sound.
MODULATION
ROOM
Parameter 1
TIME 1 – 10
Parameter 2
TONE -7 – +7
Parameter 3
MIX 0 – 10
2
ROOM
REV
HALL
Parameter 1
TIME 1 – 10
Parameter 2
TONE -7 – +7
Parameter 3
MIX 0 – 10
1
HALL
NOTE
DELAY
PPD
Parameter 1 DELAY TIME ( x100ms ) 0 – 10
Parameter 2 DELAY TIME ( x1ms ) 0 – 99
Parameter 3 FEEDBACK 0 – 10
Parameter 4 MIX 0 – 10
2
PPD (Ping-pong delay)
DELAY
MONO
Parameter 1 DELAY TIME ( x100ms ) 0 – 10
Parameter 2 DELAY TIME ( x1ms ) 0 – 99
Parameter 3 FEEDBACK 0 – 10
Parameter 4 MIX 0 – 10
1
MONO
20
1
1
2
2