16
Adjustment of brake switch
(a) After the height of brake pedal has been well adjusted, loosen the lock nut of brake switch;
(b) Unplug the plug to disconnect the lead;
© Turn the switch so that the clearance A is equal to l mm;
(d) Confirm that the brake light is On when the brake pedal is depressed.
4.3.4 Parking brake
The parking brake is mechanic and internal expanding. It is built-in on the wheel brake. It shares the brake shoe
and drum with the foot brake. When the handle of parking brake is drawn, the brake handle drives the hand tie
rod through the brake dragline (Fig.4-10). This tie rod pushes the push rod of hand brake to the right with the
help of the pin playing the role of pivot and enables the brake shoe and brake drum to tension and keeps the
wheel from running.
During the driving, you have to completely loosen the parking joystick to get the parking brake switch engaged,
otherwise, the forklift won’t be activated.
Adjustment of brake force: when the regulator is turned clockwise, the brake force increases; when turned
counterclockwise, the brake force decreases.
Traction: 20～30kg Note: adjust by turning the screw inside the regulator.
To Next Page
Loading...
General