43
VI. Maintenance of FE triple pivot battery forklift
When a forklift is brought into use, cares must be given to the operation. Adjustment, maintenance and service
should be done in time so as to keep the forklift constantly in good working condition. The following measures
should be taken for this purpose.
6.1 For a new forklift, the gear oil in the differential and reduction gear should be replaced at the 100th working
hour and retighten all fasteners.
6.2 The clearance between the drive and driven gear in reduction gear should be adjusted again after operated
for the 200th hour.
6.3 The maintenance of motor, electronic control and battery pack should be done respectively according to the
provisions in their instructions.
6.4 All connectors should be checked once every month.
6.5 Waterproof measures should be taken for the forklift. Rinsing with the hydraulic giant should be avoided.
Outdoor use in rain day should be avoided.
6.6 For the lifting motor switch, dirt on the photoelectric coupler should be often cleaned.
6.7 The surface of battery should be kept clean and dry and dirt should be often removed.
6.8 After normal use, the forklift should be subject of regular maintenance according to the following table.
To Previous Page
Loading...
General