zortrax M Series User Manual

©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered
trademarks of Zortrax and are subject to legal protection.
24
11. Attach the spool holder at the back of the printer. Using the buckles, attach the material guide
to the extruder cable.
12. Place the material spool on the holder so that the marking on the spool is visible. The spool
should rotate anti-clockwise. Next, feed the material into the extruder through the material guide.

zortrax M Series Specifications

General

Brand	zortrax
Model	M Series
Category	3D Printers
Language	English