5
Food and beverages should be kept away from both the 3D printers and 3D printed objects.
While operating Zortrax devices, all measures regarding health and safety provided in this User Guide
as well as in separate regulations should be taken into account.
Electrical Safety
Zortrax M Series 3D printers have been tested for compliance with Low Voltage Directive. In order to
ensure the highest safety standards, including protection against short circuit, overload, overvoltage
and printer overheating, do not attempt to modify the printer and do not use electronic replacement
parts other than those recommended by the Manufacturer.
Replace electronic units according to the instructions and be particularly careful while using the tools
supplied with the printer.
Before plugging the power cable into the outlet, make sure that the power supply voltage in the outlet
matches the required value provided on the nameplate at the back of the printer. Avoid overloading
the outlet with too many devices.
The printer must be well-grounded. Always make sure that the ground complies with local and na-
tional regulations.
Use only the original power cable supplied with the printer. Do not damage, cut or repair the cable.
A damaged cable should be immediately replaced with a new one.
All maintenance and repair work should be carried out while the device is o and unplugged. Do not
expose the device to moisture and liquids. Modications such as soldering of electronic subunits are
forbidden.
Mechanical Safety
Zortrax 3D printers have movable components, such as the drive belts, Z-axis screw, extruder or plat-
form. Therefore, it is forbidden to reach into the printer or put anything inside the printer when it is
running, about to start running or at rest. This may lead to serious injuries or damages.
Tools and accessories from the Starter Kit box should be used with special care for intended purposes
only. Improper use may cause serious injuries.
While following post-processing procedures, wear safety gloves and glasses in order to avoid injuries
that may be caused by sharp edges and fragile elements of the models.
To avoid injuries, be particularly careful while removing the prints from the platform. Always wear
safety gloves and glasses.
To Next Page
Loading...
Need help?
General
