zortrax M300 Manual

Unscrew the self-aligning bearing of the axis that holds the lower long belt to be
replaced. Use a wrench or pliers to hold the nuts of the screws.
UNSCREWING THE SELF-ALIGNING BEARING, PART 2
Unscrew the other self-aligning bearing of the axis that holds the lower long belt to be
replaced. Use a wrench or pliers to hold the nuts of the screws.
LOWER LONG BELT REMOVAL

zortrax M300 Specifications

General

Build Volume	300 x 300 x 300 mm
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Connectivity	SD Card
Operating System	Windows, macOS
Software	Z-SUITE
Printing Speed	up to 100 mm/s
Heated Bed	Yes
Nozzle Temperature	up to 290°C
Supported File Formats	.stl, .obj, .dxf, .3mf
Supported Materials	Z-ULTRAT, Z-HIPS, Z-GLASS, Z-PETG
Power Supply	100-240 V, 50/60 Hz