• Default Policy: Set how to handle the packet if none of the rules matches.
• MAC address: Set the MAC address that will be filtered.
• Dest. IP Address: Set the destination IP address that will be filtered.
• Source IP Address: Set the source IP address that will be filtered.
• Protocol: Set which protocol will be used for filtering.
• Dest. Port Range: Set the destination port numbers that will be filtered
• Source Port Range: Set the source port numbers that will be filtered.
• Action: Set how to handle the packet if it matches the rule.
• Comment: Type comment for the filter settings.
Notes:
Filtering rules are matched one by one. Once a provision is met, it will not continue to match the rules
listed below.
Click Apply to confirm your configuration.
Click Delete to remove the rule which you selected.
Click Reset to restore default values.
To add a new rule:
1. Select Enable in the Basic Settings area.
2. Click Apply.
To Next Page
Loading...
