6 Confidential and Proprietary Information of ZTE CORPORATION
Resetting the 4G Mobile Hotspot
• Press and hold the WPS and Power buttons simultaneously until the LCD turns off; then release the
buttons and the 4G Mobile Hotspot will restart automatically and restore to the factory default settings.
The 4G Mobile Hotspot will display ―Restarting…‖ which indicates a successful reset to factory
defaults. You can also reset the 4G Mobile Hotspot settings through the web admin page.
• is a trademark of SD Card Association.
LCD Screen Indicator
4G Mobile Hotspot Icon Indicators
Network signal strength. The antenna to the far left counts as one bar. More bars
means better coverage.
4G network type, which means the device is being connected to a 4G network.
Edge network type, which means the device is being connected to an Edge network.
GPRS network type, which means the device is being connected to a GPRS network.
Network signal not detected.
New message received, and the number beside the icon indicates the number of the
unread messages.
Wi-Fi is not being broadcast. A short press of the ―WPS‖ button will turn on the
Wi-Fi radio.
Wi-Fi is being broadcast, and the number of the connected users is indicated to the
right of the Wi-Fi antenna (maximum of 5 total).
Battery power indication. The battery indicator will flash when the battery is
almost drained.
Hardware Installation
About SIM Card
Avoid handling the SIM card unnecessarily. Hold the card by the edges to prevent static damage. Keep
the SIM card away from electrical and magnetic appliances.
If you cannot get T-Mobile wireless service, please ensure:
1.Your T-Mobile service has been activated and you have a mobile phone number.
2.You are in an area with T-Mobile network coverage
To Next Page
Loading...
